Pre-Wired 1.5" Big Daddy MX-T Bars for the 2013-2024 Breakout

OUR PRE-WIRED 1.5" BIG DADDY MX-T BARS FOR THE 2013-2024 BREAKOUT COME IN A WIDE VARIETY OF SIZES RANGING FROM 12" TO 18". AVAILABLE IN GLOSS BLACK OR THE HIGHEST QUALITY CLASSIC CHROME.

With the Harley-Davidson Sportster (2014-2021), Dyna (2012-2017) and Softail models (2011-2021 , Street Bob, Low Rider/ S, Heritage, Deluxe, Slim, Fat Bob, Breakout and Fat Boy) the ability to purchase pre-wired bars is typically expensive. The wiring for your stock switches is hardwired into your controls and does allow for the same solution that is available for the touring models.

We have designed a solution that is extremely simple and far less expensive. Allowing you to use our Prewired bars with your existing switches and turn signals.

Our bars come with the control and turn signal extensions Pre-Wired along with self-solder/heat shrink connectors.

You simply cut your control and turn signal wires, strip a small portion of each, place them into our pre-soldered/heat shrink connectors and shrink them.

We have done the hard work for you, leaving only the finishing touches up to you! Really just that simple! In addition to much more cost effective! The cost of your control and turn signal extensions (and TBW if needed) is well over $100.

With our Prewired solution you get fully extended harnesses. No additional extensions necessary! Also you will not have to look at the bulky extension connections that typically show when installing harness extensions on your bike. Finally an all in one, prewired solution for your softail or sportster that wont break the bank!

MIRRORS AND CONTROLS ARE NOT INCLUDED AND ONLY SHOWN FOR REFERENCE!!